You must be logged in and verified to contact the designer.
This mount setup attaches to the Skeleton Chassis REAR frame rails and accepts the Axial Bumper directly. Axial part number聽AX80126聽shown here:聽http://www.axialracing.com/products/ax80126聽and then accepts the bumper post setscrew pins for attaching the bumper to the mount.聽The mount sides will bolt to the frame using聽M3 x 8 screws, and then can bolt to the rear body post on the Jeep Hardbody to make a solid solution for rear attachment.聽The longer rails attach to the rear Skeleton shock tower holes using聽M3 x 8 screws and then you can use the reversible clip to hold down your battery pack in the rear of the Jeep Hardbody. The side rails and clip are reversible to get you 4 positions for battery clamping depending on the size of pack you are running. We recommend 2200mah 2s and 1300mah 3s battery packs in the rear of the Jeep. The battery hold down strap is secured using standard body pins and is easily removed after the whole body is installed. There's no need to remove the body for a battery change anymore.聽Looks great on the Skeleton Jeep builds,聽and can be used as a slide-through body mount if you drill 2 holes in the front of the Jeep Hardbody.聽Check out our pictures.聽This mount set comes with 2 battery straps, although only one is needed. You'll have a spare. Use only one strap at a time to clear the rear axle movement under the truck.聽INSTRUCTIONS:聽Break away each component from the tree, clean out holes with a small drill removing only the dust from printing. Install on the truck.聽